Everbuild Anchorset Red 380P Polyester Resin - 380ml

Anchorset is a rapid curing one shot two-part chemical anchoring cartridge system based on an unsaturated polyester resin in styrene. Applied in one single action to produce a cost effective, tough, chemical resistant fixing. Anchorset is ideal for close-to-edge applications unlike expansion anchors as no stress is placed on the surrounding substrate. Versatile in use, anchorset is suitable for fixing wall tiles, starter bars, studs, bolts or large screws in a wide range of substrates including brickwork, concrete, masonry, stone and PFA blocks. Hollow base materials can be securely fastened into by using anchorset in conjunction with a sleeve or sieve.

Application

Attach the mixing nozzle to the cartridge, screw down hand tight. Place cartridge into the anchorset dispensing gun. Open the cartridge by pressing the green end of the colour coded valve. Gradually pressurise the cartridge by activating the hand trigger a few times until material passes through the mixing nozzle. Stop pressurising to allow the material to flow until an even colour is obtained, approximately 5 to 6 inches of extruded material should be adequate. Press the red end to close to the valve. Insert the nozzle into the base of the hole and open valve again by pressing the green end and activate the trigger, withdraw the nozzle slowly as the hole fills. Once the required fill is achieved shut off the valve and wipe excess material. Insert the fixing slowly slowly with a rotating action to the desired depth. Once all applications have been carried out, release the pressure by pressing the slide release arm on the back of the trigger stop and pulling back the slide rail.

6 Items

You might also like

Add Related products to weekly line up

other products

16 other products in the same category:
Product added to compare.